1. This machine is composed of feeding hopper, crushing device, screw device, support device, filtering screen, juicing container and fruit residue discharging spout, etc.

2.There is the crushing device on the feeding hopper, the crushing device will crush the fruit into 2-3mm by blades, and then the crushed fruit will enter the juicing system directly, which will improve the juicing capacity highly.

juice

Model	Size (mm)	Power (kw)	Juice yield	Capacity	Material	Weight
TPP-ZZ5	11504501450mm	1.5+1.5KW	50%	0.5ton/h	Stainless steel 304	131kg
TPP-ZZ10	13005001550 mm	1.5+3kw	50%	1ton/h	Stainless steel 304	150kg
TPP-ZZ15	13505501750mm	1.5+4kw, 380V	50%	1.5ton/h	Stainless steel 304	260KG
TPP-ZZ25	15807602050mm	4+11kw 380V	50%	2-3ton/h	Stainless steel 304	520kg

JUICE MACHINE

1.The primary component of a spiral juice extractor is the spiral.

2.The spiral widens gradually in diameter along the direction of the material residue outlet, while the pitch decreases.

3.As the material is pushed by the spiral, the reduction in the volume of the spiral cavity leads to squeezing of the material.

juice machine

1. The raw material is fed into the hopper, where it is subjected to pressure as it moves along the spiral.

2.The juice extracted from the material passes through a filter mesh into a container at the bottom, while the waste material flows out through the space created between the spiral and the pressure-adjusting conical section.

3.The movement of the pressure-adjusting head along the axis can adjust the size of this space. When turning the handwheel bearing seat towards the hopper end from the device's sludge discharge groove, the pressure-adjusting head moves to the left, reducing the space; conversely, it increases the space.

4.By adjusting the size of the space, the resistance to sludge discharge can be altered, thereby affecting the sludge discharge rate. However, if the space is too small, some of the sludge particles may be squeezed out through the filter mesh along with the juice, even though the juice yield increases.

5.The size of the space should be determined based on the specific process requirements of the user.

Juice 7